How do I adjust my motion detection areas in dmss?

Text guide:

step 1:

Once you have the camera you want to adjust the motion detection area on selected, tap on the Device Details button in the top right.

step 2:

Now on the Device Details page, tap on “Remote Configuration” towards the bottom of the page

step 3:

From the remote configuration page, tap on “Video Detection,” and then on the drop-down menu, tap on “Motion Detection”

step 4:

On this page, you will want to turn on “enable” and “advanced Configuration.” New options will open up on the page, tap on “Region Setting”

step 5:

This screen can seem a little complicated so I will go over it here

All of the regions covered in the red squares are areas where your cameras will not detect motion. At the start, the entire screen will be full of red squares and you can use the tool indicated by the pencil to remove them and create motion detection regions on the camera.

If you have accidentally made the motion detection area too large, or want to remove the motion detection from a location for any reason, the paintbrush icon on the bottom will change your ability from removing red squares to adding red squares, removing motion detection zones.

Both removing and adding motion detection zones is done by dragging your finger across the screen, it will make a box, and depending on what tool you have selected, whatever area falls under the box will be changed accordingly.

The final tool, the hand icon, is only relevant if you are zoomed into the camera, this allows you to tap and drag across the screen in order to move around the view. If the camera is in full screen already (which it is by default) it will not do anything.